LTP Colour Intensifier And Stain Block 1 lTR

How to Use

1. Prepare the Surface: Ensure the surface is completely clean, dry and free from contamination before treatment. If necessary, thoroughly clean with LTP Grimex and allow the surface to dry completely.

2. Apply: Apply LTP Colour Intensifier & Stainblock thinly and evenly using a cloth, brush, sealant applicator pad or sponge.

3. Allow to Penetrate: Leave the product to penetrate for approximately 15–30 minutes.

4. Remove Excess: Wipe the surface thoroughly with a clean, dry, lint-free cloth to remove all excess product. The treated surface should retain a natural matt appearance.

5. Additional Coats: For more absorbent surfaces or where stronger colour enhancement is required, additional coats can be applied. Allow approximately 30–60 minutes between coats.

6. Allow to Cure: Allow approximately 2 hours for initial drying and around 3 days for full resistance. Keep the treated surface completely dry for a minimum of 3 days after application.

Coverage

Coverage varies considerably depending on the porosity, absorbency and number of coats applied.

• Lower Porosity Surfaces: Approximately 1–2 litres per 10m²
• Higher Porosity Surfaces: Approximately 3–4 litres per 10m²
• Typical Coverage: Approximately 2.5–10m² per litre

Drying & Curing

• Penetration Time: Approximately 15–30 minutes
• Between Coats: Approximately 30–60 minutes
• Initial Drying Time: Approximately 2 hours
• Full Resistance: Approximately 3 days
• Keep the treated surface completely dry for a minimum of 3 days
• Do not apply in direct sunlight
• Do not apply above 25°C
• Switch off underfloor heating before application
• Ensure good ventilation during application

Aftercare

• Floors: Clean regularly with LTP Waxwash
• Walls & Work Surfaces: Clean regularly with LTP Stonewash

Using suitable maintenance products helps preserve the appearance and performance of the treated surface.

Important Information

• LTP Colour Intensifier & Stainblock is difficult to remove once fully cured
• Always test on an inconspicuous area before full application
• Do not over-apply
• Remove all excess product before it dries
• Excess sealer left on the surface can produce an unwanted glossy or varnished appearance
• The surface must be completely clean and dry before treatment
• Do not apply in direct sunlight
• Do not apply above 25°C
• Do not apply with underfloor heating switched on
• Keep treated surfaces dry for at least 3 days
• Use in a well-ventilated area
• Follow the current product label and safety instructions

Storage

• Store in a cool, dry and frost-free environment
• Shelf Life: Up to 4 years in unopened containers

Product Information

• Brand: LTP
• Product: Colour Intensifier & Stainblock
• Size: 1 Litre
• Type: Colour Enhancing Impregnating Sealer
• Finish: Enhanced Matt / Natural Finish
• Protection: Water, Oil, Grease, Dirt & Staining
• Application: Interior & Exterior
• Suitable For: Walls & Floors
• Initial Drying Time: Approximately 2 Hours
• Full Resistance: Approximately 3 Days
• Product Code: LTP/13/1
• EAN: 5031220013018